1. Go to the back of the store where the bulk CO2 tanks are located (pictures included on this page)

2. There are 4 gauges located on top of the main bulk tank, you will need to check each gauge (pictures included on this page)

• The tank gauge needs to show in the green meaning it is full

  • If this gauge is anything but in the green range, you will need to contact your CO2 supplier AND follow the instructions on this page for 'Switch to Backup CO2'

• The vessel pressure gauge needs to show the needle in the blue range

• The bulk coke gauge needs to show in the blue between 60lbs and 65lbs

• The carbonated pressure gauge needs to show in the green between 90lbs and 120lbs

If any of these gauges are not showing in the proper range do the following

• follow the instructions on this page for 'Switch to Backup CO2'

• follow the instructions to submit a ticket here

1. Locate the backup CO2 tank 

   • Check backup CO2 tank gauges (pictures included on this page)

     • Ensure the gauge is within the green range 

     • If back up tank(s) is empty, contact CO2 supplier immediately 

2. Twist the knob to the left to open backup tank

3. Go to the main multiplex panel (pictures included on this page)

4. Locate the 'Bulk CO2 65 PSI Inlet' and turn blue knob down to set in the 'open' position

5. Locate the 'Bulk CO2 95 PSI Inlet' and turn blue knob down to set in the 'open' position

6. If after going into backup the problem still persists, contact your CO2 supplier AND follow this Final Step