Locate controller (behind UHC eProduction Monitor)
Press the power button
Wait for controller to turn off
Wait an additional 15 seconds
Press power button again
Wait 10 minutes for controller to boot up
If issue persist:
Final Step

Check to see if UHC monitor is on:

If on and displaying correctly:
Locate baked monitor controller (behind baked eProduction Monitor)
Press the power button
Wait for controller to turn off
Wait an additional 15 seconds
Press power button again
Wait 10 minutes for controller to boot up
If issue persist:
Final Step

If on and displaying incorrectly:
Locate UHC controller (behind UHC eProduction Monitor)
Press the power button
Wait for controller to turn off
Wait an additional 15 seconds
Press power button again
Wait 10 minutes for controller to boot up
If issue persist:
Locate baked monitor controller (behind baked eProduction Monitor)
Press the power button
Wait for controller to turn off
Wait an additional 15 seconds
Press power button again
Wait 10 minutes for controller to boot up
If issue persist:
Final Step

If off:
Locate UHC controller (behind UHC eProduction Monitor)
Press the power button
Wait 10 minutes for controller to boot up
If issue persist:
Locate baked monitor controller (behind baked eProduction Monitor)
Press the power button
Wait for controller to turn off
Wait an additional 15 seconds
Press power button again
Wait 10 minutes for controller to boot up
If issue persist:
Final Step

Locate controller (behind UHC eProduction Monitor)
Press the power button
Wait for controller to turn off
Verify all cables are securely pressed into controller
Wait an additional 15 seconds
Press power button again
Wait 10 minutes for controller to boot up
If issue persist:
Final Step

Verify there is paper in the printer
Verify USB cable is securly connected to bottom of printer
Verify printer is powered on
If not make sure power cable is securely connected to printer
If issue persist:
Final Step

Final Step